EasyPatchProject reference: 270539
Funded under :
Prefabricated CFRP Parts
Total cost:EUR 149 420
EU contribution:EUR 112 050
Call for proposal:SP1-JTI-CS-2010-01See other projects for this call
Funding scheme:JTI-CS - Joint Technology Initiatives - Clean Sky
Due to the increasing use of carbon fibre reinforced plastics (CFRP) in aircraft structures a growing demand for repair concepts can be observed. Today’s repair concepts are mainly focused on the refurbishment of parts at the manufacturer’s site in order to reduce waste. Additionally, specialized service providers travel on call to repair parts that are already installed. The next step to be undertaken is transferring the actual repair from the manufacturer to the airline thus further reducing an aircraft’s down time.
In order to allow the repair of damaged CFRP-parts at an aircraft maintenance hangar it is necessary to provide a repair concept that employs standardized repair-patches. These patches combine the ability to restore structural integrity with ease-of-use. The quality of repair depends on the consistency of mechanical properties throughout the structure. Two factors play a key role in that: the contact-area between patch and part on one side and the patch lay-up sequence on the other. Using standardized repair patches it is not always possible to find a perfect match, neither in patch size nor in lay-up. Hence, the influence of different patch sizes, stiffness variations, surface treatments, and chamfer designs needs to be investigated. Simulation will be used to check on a variety of failure sizes and possible patch designs. Purposefully damaged parts will be produced and repaired with patches of standardized design. The success of repair will be evaluated through mechanical testing.
EU contribution: EUR 112 050
Tel.: +49 5323 722090
Fax: +49 5323 722324