CS-GYROProject reference: 271494
Funded under :
MEMS gyrometer for wing behaviour measurement
Total cost:EUR 800 000
EU contribution:EUR 600 000
Call for proposal:SP1-JTI-CS-2010-02See other projects for this call
Funding scheme:JTI-CS - Joint Technology Initiatives - Clean Sky
"The subject of this proposal is the design of a MEMS gyroscope for SFWA purposes. This is a high-end application, stemming from its noise and stability requirements.
We will not develop a completely novel device, i.e. with entirely new design principles, fabrication processes, etc. On the contrary, the performance of Sensonor’s existing, qualified high-end product STIM202 is very close to the targeted specification. Thus, the improvement of a rather limited number of technical issues is required to satisfy the specification. STIM202 is a 1, 2 or 3 axes gyroscope. It meets this Call’s specification in noise and short term stability. Long term stability is also very good, while an effort remains to establish those design and technology improvements that are needed to explicitly make the sensor fulfill the SFWA specification. The route to attain this goal is the focus of this proposal.
Sensonor’s long track record in MEMS places the company in a unique position in extreme reliability silicon MEMS. More than 2 million MEMS gyros, 250 million MEMS accelerometers, and 250 million MEMS pressure sensors designed and manufactured by Sensonor have been shipped, with an impressive field failure rate of less than 0.1ppm. This is ultimate proof of the extreme reliability achievable in silicon MEMS by Sensonor.
In the project, we will identify and ascertain a list of improvements, to limit and focus the efforts. This approach translates to best project efficiency, short time-to-market and low technical risks.
At the end of this project, the required improvements will have been attained, and the corresponding new and improved gyro specification arrived at. It will positively have been proven that the SFWA specification is met with these improvements and production can start immediately."
EU contribution: EUR 120 000
Tel.: +47 95773905
EU contribution: EUR 480 000
Tel.: +47 33035000
Fax: +47 33035005