UltrameltProject ID: 650989
H2020-EU.2.3.1. - Mainstreaming SME support, especially through a dedicated instrument
An innovative, disruptive, advanced technology for ultrasonic flow enhancement of injection moulding that significantly reduces cooling times improves productivity
Całkowity koszt:EUR 71 429
Wkład UE:EUR 50 000
Kraj koordynujący:United Kingdom
Topic(s):NMP-25-2014-1 - Accelerating the uptake of nanotechnologies, advanced materials or advanced manufacturing and processing technologies by SMEs
Zaproszenie do składania wniosków:H2020-SMEINST-1-2014See other projects for this call
System finansowania:SME-1 - SME instrument phase 1
Injection moulding is a large portion of the EU thermoplastics processing industry. In 2008, its value was €55 bn, but fell to €43 bn in 2009. The industry continues to contract, struggling against low cost economies. While energy cost savings are welcome, cycle time dominates cost so reducing it is key & will increase productivity. Cycle time is dominated by cooling time, which depends on many factors including melt temp. Polymers are often heated well above the ideal melt temp. to aid injection by lowering viscosity. Similarly, very high injection speeds/pressures are used. But we show later that these methods have drawbacks. Our idea is to apply ultrasonic energy into the molten polymer just before it enters the cavity. This can achieve as much as 60% reduction in melt viscosity, enabling a significant reduction in melt temp. while still being able to fill the mould. Lower embodied heat reduces heating/cooling time & energy.
Key benefits are that melt temps. can be maintained and the lower viscosity used to enable easier filling of existing parts with lower internal stresses; melt temp. can be reduced significantly, reducing thermal degradation, energy consumption & cooling time. Or melt temp is maintained and much longer flow paths or thinner wall sections can be filled, offering a step change in design for thinner parts with even shorter cooling time. The ultimate goal of the Phase 2 project is to achieve market readiness of the ‘Ultramelt’ process, with follow-on Phase 3 achieving commercialisation in the EU marketplace. This technology could enable EU moulders & extruders to increase productivity by 50%, increasing competitiveness, enabling them to regain market share and capitalise on new business opportunities.
Wkład UE: EUR 50 000
MAIN STREET THE OLD ELECTRICAL
NG32 3LT WELBY GRANTHAM