Obiettivo Mechanical ignition sources are important under the ATEX Directive, but little is known of the risk associated with them. Characteristics of sparks and hot spots produced by impact, friction and grinding are to be measured. Simulated ignition sources with the same characteristics will be used to measure the sensitivity of explosive environments to ignition and this sensitivity will be characterized in relation to standard measurements of the ignitability of the explosive substances. The results of the two parts of the experimental programme will be combined to categorize equipment intended for use in potentially explosive environments on the basis of the type of mechanical ignition sources likely to arise from a specific design and method of operation and the environments likely to be ignited by these sources. A proposal for a methodology for inclusion in European Standards on preparing Ignition Hazard Assessments will be produced. Campo scientifico social sciencessociologygovernancecrisis management Programma(i) FP5-GROWTH - Programme for research technological development and demonstration on "Competitive and sustainable growth 1998-2002" Argomento(i) 1.1.3.-6. - RTD Activities of a Generic Nature : Measurements and Testing Invito a presentare proposte Data not available Meccanismo di finanziamento CSC - Cost-sharing contracts Coordinatore Health and Safety Executive (HSE) Contributo UE Nessun dato Indirizzo Broad Lane S3 7HQ Sheffield Regno Unito Mostra sulla mappa Costo totale Nessun dato Partecipanti (2) Classifica in ordine alfabetico Classifica per Contributo UE Espandi tutto Riduci tutto INBUREX GMBH CONSULTINGGESELLSCHAFT FUER EXPLOSIONSSCHUTZ UND ANLAGENSICHERHEIT Germania Contributo UE Nessun dato Indirizzo August-Thyssen-Strasse 1 59067 HAMM Mostra sulla mappa Costo totale Nessun dato INSTITUT NATIONAL DE L'ENVIRONNEMENT INDUSTRIEL ET DES RISQUES Francia Contributo UE Nessun dato Indirizzo PARC TECHNOLOGIQUE ALATA 60550 VERNEUIL EN HALATTE Mostra sulla mappa Costo totale Nessun dato