Community Research and Development Information Service - CORDIS

Development of colloidal processing for critical components

This study developed an aqueous colloidal processing route for the manufacture of ceramics, namely yttria stabilised zirconia ceramics, with improved microstructure, strength, reliability and thermal shock resistance after firing. The potential properties of the zirconia were demonstrated in a fuel cell, and also in other ceramic parts, such as needles and fibres.

Zirconia powders were synthesised and characterised to confirm purity, grain size and surface structure. These powders were colloidally processed. This involved the comminution of the raw zirconia dispersed in a surfactant solution whereby the particles were reduced to less than 1 micron in size after milling for a set time. To this stable dispersion, a polymeric solution containing binder and plasticiser was added. Stability of this dispersion was maintained for a reasonable length of time and this slurry passed through a 1 µm filter. After removal of excess water, the plastic paste was extruded to form thin-walled tubes which were demonstrated in a 1000 tube fuel cell stack.

Extruded tubes made by the conventional powder mixing process were compared with tubes made by the new colloidal process. The test results showed that the colloidal process gave substantially higher strengths of over 500 MPa, plus good reliability, thus demonstrating the benefits of the new method.

A zirconia fuel cell system was designed and the system construction was studied. Individual cells were designed to fit within this system and cells were made by the colloidal process route, dried, fired and studied. These cells were incorporated into a 200 tube and a 1000 tube reactor. The entire system, including the fuel and gas flows, ignitor, etc was controlled by a computer. Both reactors survived rapid warm-up times of 60 seconds without catastrophic failure, in contrast to the 5 hours needed for the Westinghouse tubular design to reach the operating temperature of 800 C. Electricity and heat were successfully produced using natural gas as the fuel and air as the oxidant. This device could have enormous benefit for cogeneration applications.


Kevin KENDALL, (Professor of Materials Science)
Tel.: +44-1782-583467
Fax: +44-1782-715944
Follow us on: RSS Facebook Twitter YouTube Managed by the EU Publications Office Top