Community Research and Development Information Service - CORDIS

H2020

SafeAST Report Summary

Project ID: 691497

Periodic Reporting for period 1 - SafeAST (Continuous structural condition tank integrity monitoring of Above Ground Storage Tanks, aka “SafeAST, no entry: no empty.”)

Reporting period: 2015-12-01 to 2016-11-30

Summary of the context and overall objectives of the project

Leakage of fluids from above ground atmospheric storage tanks is a major issue. Most countries have stringent regulatory requirements for the avoidance of leaks of potential pollutants from tanks, so that there is considerable pressure on tank and terminal operators to ensure that leaks do not occur. Other than cases where catastrophic failures of tanks have occurred, the main site for leakage is the tank floor, which may degrade in service owing to corrosion or, in some cases, cracking at welds. Well-founded procedures have been developed for the inspection and repair of tank floors, for example those in API standard 653 (API 2007), but the operations required to empty, clean and make tanks safe for regular internal examinations are costly and time consuming. Further, the examinations are usually scheduled on an equal time basis and do not take account of the varying rates of degradation occurring in different tanks. Tanks which require the highest priority action may therefore not be examined or rectified first.

The monitoring technology, which has been under development at Plant Integrity for a number of years, involves the use of low frequency ultrasound to examine the whole of the tank floor from a number of permanently attached sensors around the perimeter on the outside. The long distance propagation characteristics of the ultrasonic waves used allow signals from one side of the tank to be picked up by a sensor on the other side (up to 30m diameter). By using combinations of transmit and receive amongst the set of sensors, it is possible to cover the whole floor area. By taking readings from the sensors regularly, long term trends in the condition of the floor can be determined. In this way, short term variations, for example from temperature fluctuations or changes in the fill levels in the tank, can be separated from changes in the physical condition of the floor. In this way, tanks needing priority attention may be identified and the more rigorous internal examinations may be concentrated on these.

The main goal of the project is to provide performance data to demonstrate the capability of a non-invasive ultrasonic guided wave monitoring system to detect time dependent degradation of the Atmospheric Storage Tank (AST) floors that may give rise to leaks.

Specific objectives are:
• Instrumentation and remote monitoring of specified tanks at identified refineries;
• Generation of condition reports on tank floors monitored;
• Review of detection and assessment performance of the non-invasive system in comparison with internal inspection (MFL, ultrasonic and visual) results;
• Production of a report detailing capabilities and limitations of the system

Tank floor monitoring system data may be gathered at pre-determined intervals while the tank is in operation so that monitoring without service interruption can be achieved. The test results are stored in the unit itself and external hard disks and also are copied on Pi servers at intervals for archiving and analysis.

Work performed from the beginning of the project to the end of the period covered by the report and main results achieved so far

Work performed from the beginning of the project until date can be summarised in bullet points as follows:

* System requirements and system specification documents have been produced to guide the development.
* This was followed by the identification of Improvement opportunities for the current application.
* Based on the research work carried previously, an installation procedure was already in place. However, there are a few changes which are needed in order to have a robust system for reliable monitoring.
* Validation of equipment and system performance has been initiated at experimental facilities and on operational tanks.
* The consortium initiated discussions on the review of requirements against applicable standards.
* There has been an intensive disemination and explaoitation program (including developing promotional material and exhibitions) during the first reporting period.

Progress beyond the state of the art and expected potential impact (including the socio-economic impact and the wider societal implications of the project so far)

The main technical outcome of the project will be the availability of data to support the application of non-invasive technology for in-service monitoring of the condition of tank floors. Such data are required for both internal justifications by tank and terminal operators for the use of this technique on live plant and as evidence to support cases to regulatory bodies for its application.

The use of non-invasive monitoring will allow:
• Internal inspection intervals to be extended for tanks with minimal degradation,
• Identification of tanks that require action for examination and repair before the assumed time for the next inspection is reached.

The long-term benefits of the application of non-invasive technology are:
• Significant savings in the direct costs of taking tanks out of service on a time-interval basis, as high priority tanks can be identified and taken out of service on the basis of need;
• Savings in the indirect consequential costs of taking tanks out of service, in terms of the need for additional storage capacity;
• Improved knowledge based long-term planning of outages and minimisation of disruption to fluid management operations;
• Reduction in the likelihood of leaks occurring in tank floors and associated environmental contamination, through prioritisation of tank investigation and repair;
• Reduced risk of catastrophic failure, pollution, loss of inventory, fire and explosion;
• Reduced risk to human life sue to less interference with polluted environments.

Related information

Record Number: 198073 / Last updated on: 2017-05-16
Follow us on: RSS Facebook Twitter YouTube Managed by the EU Publications Office Top