Objective Camber is a geometrical defect that causes difficulties in guiding the product and can cause cracks in the tail ends of coils in finishers. Several causes can be the origin of this defect. Camber measurement in rolling mills does not exist, presently. Deviation measurement cannot give sufficient data because it does not take into account the possible uncontrolled movements of the product. This project intends to develop continuous camber measurements at the exit of the rougher, with a resolution of <2.5 mm/m, using several successive deviation measurement devices. Programme(s) ECSC-STEEL C - Medium-term guidelines for the ECSC steel RTD programme of research and pilot/demonstration projects, 1996-2002 Topic(s) T4 - On-line control Call for proposal Data not available Funding Scheme CSC - Cost-sharing contracts Coordinator SOLLAC DUNKERQUE EU contribution No data Address rue du Comte Jean Grande-Synthe 59381 DUNKERQUE CEDEX 1 France See on map Total cost No data Participants (2) Sort alphabetically Sort by EU Contribution Expand all Collapse all EES VAI Netherlands EU contribution No data Address 4560 SINT JANSTEEN See on map Total cost No data INSTITUT DE RECHERCHES DE LA SIDERURGIE FRANÇAISE France EU contribution No data Address Immeuble "PACIFIC", La Défense 7 11/13 Cours Valmy 92800 PUTEAUX See on map Total cost No data
