Final Report Summary - SSNMRMETHOD (Development and application of new nuclear magnetic resonance methodologies for structure determination of solid or semi-solid samples)
This method relies on the following concept. To measure a 1H-1H interatomic distance by solid-state NMR, we first need to be able to acquire a 1H spectrum in which the different peaks corresponding to the nuclei of interest look well resolved. Once the high-resolution 1H spectrum is available, the modulation of the intensity of these peaks in function of an evolution time under a suitable pulse scheme can be quantitatively related to the distance between the corresponding atoms. As mentioned above, to get high-resolution spectra, a suitable homonuclear-decoupling sequence must be applied. Ideally, the best spectral resolution attainable using homonuclear decoupling corresponds to a complete removal of the 1H-1H dipolar coupling interaction; however, it is exactly this interaction we want to exploit to get the information about distance. Therefore, I looked for experimental conditions leading to a slight detuning from the optimal decoupling conditions; this would allow only a small fraction of the dipolar interaction of interest to be reintroduced, guaranteeing high spectral resolution. Inspired by a recent paper by Prof. P. K. Madhu, Mumbai, India, and Prof. M. H. Levitt, Southampton, United Kingdom (UK), I found these conditions in the application of the homonuclear-decoupling irradiation under specific rotor-synchronised conditions. With this expression, we mean that the decoupling irradiation block repeats synchronously with the rotation of the sample around the sample holder (called rotor) rotation axis. It turns out that these conditions are particularly appropriate, since, operating under average radio-frequency field and spinning rate conditions (about 80 kHz and 15 kHz, respectively) only reintroduces a maximum of 3 % of the full dipolar coupling, which is consistent with good resolution conditions. Most importantly, the slight amount of dipolar coupling which is reintroduced into the experiment is enough to modulate the signal intensity and hence to get the information about the distance. The theoretical aspects of the methodology proposed were treated using the 'theory of symmetry-based sequences' developed by Prof. M. H. Levitt. This allowed the exact analytical expression of the signal generated by this experiment to be obtained. This analytical function shows dependence on:
1. the dipolar coupling scaling factor, that is a constant whose value depends on the experimental conditions used and can be calculated precisely through Levitt's symmetry theory
2. the dipolar coupling constant.
A simple non-linear fit of the experimental data with the analytical function thus allows the dipolar coupling to be obtained, and the distance between the two selected nuclei to be directly measured. This is the first experimental NMR method allowing the direct estimation of the internuclear 1H-1H dipolar coupling in solid systems. The method has been validated using two model systems, solid glycine and L-alanine, which were used as test samples for the measurement of a short (glycine, 1.76 Å) and an intermediate (alanine, 3.52 Å) 1H-1H distance. I was able to measure an intramolecular 1H-1H coupling in glycine, obtaining the distance between the two methylene protons (CH2) protons, with a precision of ±0.02 Å. Similarly, I used a selective pulse to isolate the intermolecular CH-CH coupling in L-alanine. This allowed this interaction to be estimated with a precision of ±0.09 Å. In both the cases, the resolution obtained is between 10 and 50 times higher than that achievable using the currently available diffraction methods (i.e. X-ray and neutron diffraction).
The method developed during my MC fellowship has the potential of paving new ways towards the quantitative determination of the tridimensional structure of solids through the use of hydrogen atoms. This approach is in principle applicable to all molecular systems whose 1H solid-state NMR spectrum is sufficiently resolved, without any a priori limitations to the study of systems lacking long-range order, like the amorphous ones. This technique has immediate application to the study of pharmaceutical systems as the active principle ingredients, typically constituted by small organic molecules organised in a crystalline structure. Moreover, because of the limitations displayed by X-ray and neutron diffraction methods in the exact location of hydrogen atoms in a crystalline solid, this methods opens for the first time direct access to the study of the hydrogen bond network often stabilising the supramolecular structure of organic solids, without even requiring monocrystals.