Objectif
The aim of the project is to demonstrate the use of a gas compression heat pump with the soil as heat source in the heating range power above 1 000 kW. Energy savings of 50% compared with a conventional boiler plant are envisaged.
During the heating periods 1982/83 and 83/84 there were longer non-availability periods of the plant mainly due to damage of the soil heat exchangers, corrosion problems in motor heat exchangers, motors failures etc.
In the heating period from October 1983 to end of April 1984 - excluding the three months interruption due to the motor failure - 919.7 MWh were produced at a gas consumption of 558 MWh, corresponding to an average PER of 1.51 or an energy saving of 51.5% compared with conventional production by the gas boilers with 80% efficiency.
Although the actually measured heat demand was in a very good accordance with the design, the expected energy cost savings were not reached. This means that the total operating costs of the gas heat pumps are always higher than those of the gas boiler. It is estimated that break even can be reached at 160% higher than today's (1985-86) gas cost value.
The heating plant of the district building in Warendorf consists of a combination of two gas heat pump units with three gas boilers to cover the peak load and produce hot water. The heat pumps are dimensioned for coverage of the transmission heat demand of 1 150 kW, two soil heat exchangers (6 800 m2, 2 100 m2) are used as heat source for the heat pumps, the heat exchangers consist of pe-tubings in parallel one besides the other in plane, they are installed in 2 depths of 0.8 and 1.8 beneath the soil surface.
The building under consideration having 17.700 square m. of heated area, was designed to have a K value of 0.2 W/square m.K. and the load was calculated under 21 Deg. C inside and 12 Deg. C outside design temperatures.
The infiltration coefficient was taken as 9,4 cubic m/h sq. m. of window surface, corresponding to an air charge of 1 time per hour.
At present energy price levels the heat pump heating capacity was designed to be about 60% of the total transmission heat demand. The construction of the plant implies the combination of both heat pumps connected to a common evaporator and condenser. Each screw compressor used, being slide valve regulated, is directly coupled to gas-otto 6 cylinder drive engine rated at 13 kW output. The refrigerant R-12 is evaporated in a flooded type evaporator of 440 kW capacity, at 10 Deg. C evaporating temperature. The condenser is an ordinary bundle type condenser, rated as 680 kW, at 55 Deg. C condensing temperature.
Heat is extracted from soil and rain water using a brine circuit operating at 2 to 5 Deg. C lower than corresponding soil temperature, and 5 Deg. C temperature differential across the evaporator. The maximum heat absorption coefficient amounts to 49 W/sq. m. of soil area.
Heating water flows first through a low temperature circuit operating at
50.9 Deg. C, and consisting of the oil-coolers, condenser and gear coolers. A partial flow of the heating water is then passed through the high temperature circuit operating at 63.5 Deg. C, consisting of the motor jacket heat exchanger and waste gas heat exchangers. A buffer store integrated into the heat pump system stores the high temperature heat and supplies the impulses for switching on and off the heat pumps and the boiler.
A special characteristic of this installation is that the mechanical room is located in the attic of the building and sound proofing is ascertained by a proper design.
Saving of 51.5% versus 55 % expected.
Champ scientifique (EuroSciVoc)
CORDIS classe les projets avec EuroSciVoc, une taxonomie multilingue des domaines scientifiques, grâce à un processus semi-automatique basé sur des techniques TLN. Voir: Le vocabulaire scientifique européen.
CORDIS classe les projets avec EuroSciVoc, une taxonomie multilingue des domaines scientifiques, grâce à un processus semi-automatique basé sur des techniques TLN. Voir: Le vocabulaire scientifique européen.
Ce projet n'a pas encore été classé par EuroSciVoc.
Proposez les domaines scientifiques qui vous semblent les plus pertinents et aidez-nous à améliorer notre service de classification.
Vous devez vous identifier ou vous inscrire pour utiliser cette fonction
Programme(s)
Programmes de financement pluriannuels qui définissent les priorités de l’UE en matière de recherche et d’innovation.
Programmes de financement pluriannuels qui définissent les priorités de l’UE en matière de recherche et d’innovation.
Thème(s)
Les appels à propositions sont divisés en thèmes. Un thème définit un sujet ou un domaine spécifique dans le cadre duquel les candidats peuvent soumettre des propositions. La description d’un thème comprend sa portée spécifique et l’impact attendu du projet financé.
Les appels à propositions sont divisés en thèmes. Un thème définit un sujet ou un domaine spécifique dans le cadre duquel les candidats peuvent soumettre des propositions. La description d’un thème comprend sa portée spécifique et l’impact attendu du projet financé.
Appel à propositions
Procédure par laquelle les candidats sont invités à soumettre des propositions de projet en vue de bénéficier d’un financement de l’UE.
Données non disponibles
Procédure par laquelle les candidats sont invités à soumettre des propositions de projet en vue de bénéficier d’un financement de l’UE.
Régime de financement
Régime de financement (ou «type d’action») à l’intérieur d’un programme présentant des caractéristiques communes. Le régime de financement précise le champ d’application de ce qui est financé, le taux de remboursement, les critères d’évaluation spécifiques pour bénéficier du financement et les formes simplifiées de couverture des coûts, telles que les montants forfaitaires.
Régime de financement (ou «type d’action») à l’intérieur d’un programme présentant des caractéristiques communes. Le régime de financement précise le champ d’application de ce qui est financé, le taux de remboursement, les critères d’évaluation spécifiques pour bénéficier du financement et les formes simplifiées de couverture des coûts, telles que les montants forfaitaires.
Coordinateur
4410 WARENDORF
Allemagne
Les coûts totaux encourus par l’organisation concernée pour participer au projet, y compris les coûts directs et indirects. Ce montant est un sous-ensemble du budget global du projet.