Objectif Camber is a geometrical defect that causes difficulties in guiding the product and can cause cracks in the tail ends of coils in finishers. Several causes can be the origin of this defect. Camber measurement in rolling mills does not exist, presently. Deviation measurement cannot give sufficient data because it does not take into account the possible uncontrolled movements of the product. This project intends to develop continuous camber measurements at the exit of the rougher, with a resolution of <2.5 mm/m, using several successive deviation measurement devices. Programme(s) ECSC-STEEL C - Medium-term guidelines for the ECSC steel RTD programme of research and pilot/demonstration projects, 1996-2002 Thème(s) T4 - On-line control Appel à propositions Data not available Régime de financement CSC - Cost-sharing contracts Coordinateur SOLLAC DUNKERQUE Contribution de l’UE Aucune donnée Adresse rue du Comte Jean Grande-Synthe 59381 DUNKERQUE CEDEX 1 France Voir sur la carte Coût total Aucune donnée Participants (2) Trier par ordre alphabétique Trier par contribution de l’UE Tout développer Tout réduire EES VAI Pays-Bas Contribution de l’UE Aucune donnée Adresse 4560 SINT JANSTEEN Voir sur la carte Coût total Aucune donnée INSTITUT DE RECHERCHES DE LA SIDERURGIE FRANÇAISE France Contribution de l’UE Aucune donnée Adresse Immeuble "PACIFIC", La Défense 7 11/13 Cours Valmy 92800 PUTEAUX Voir sur la carte Coût total Aucune donnée