Obiettivo
For five years, up to its termination in 1989, project 263 was the flagship optoelectronics project supported under ESPRIT. Composed of two groups, the project aims were to develop integrated wavelength multiplexed transmitter and receiver chips (group A), and to integrate lasers and detectors with transistor drivers and pre-amplifiers (group B).
Composed of 2 groups, the project aims were to develop integrated wavelength multiplexed transmitter and receiver chips (group A), and to integrate lasers and detectors with transistor drivers and preamplifiers (group B).
A focal point of the group A collaboration has been the optoelectronic device simulation facility.
Low loss waveguide bends, fabrication tolerant power splitters and novel wavelength filters and demultiplexers were generated using this unique facility, and many practical problemsof integrated addressed. Group B has concentrated on the development of the 2 key components required in any optical transmission system, namely the optical transmitter and the optical receiver. The main innovation of this work has been the combining of both the optical (laser of photodetector) and electronic (transistor) devices on the same semiconductor chip, an approach which offers the prospect of higher performance, lower cost, reduced sized and improved reliability compared with more conventional hybrid components.
The project made remarkable progress, and has helped to establish the technology being deployed under the RACE programme by demonstrating some of the key components required for optical broadband communication networks throughout Europe.
Integrated optoelectronics demands precise control of the semiconductor alloys grown in layers to make lasers, detectors and optical waveguides. ESPRIT 263 has strengthened the key technologies in this area, moving from LPE to MOVPE and MBE for growing InP-based compounds on InP substrates. Not only has this resulted in large area wafers of reliable composition and reproducible thickness, but losses in waveguides have fallen by a factor of ten.
Group A's work on integrated transmitters has explored the fabrication of laser sources operating at two wavelengths separated by 30 nm around 1.55 micron. Either direct or external modulation is used to encode digital information onto these optical carriers, which are combined onto a single fibre using a wavelength division multiplexer. The receiver comprises a wavelength demultiplexer to separate the two optical carriers, together with integrated photodetectors to convert the signal back into electricalform.
In developing the transmitter components, STL and CGE have improved their narrow linewidth DFB lasers and demonstrated the ability to fabricate sources operating at different wavelengths on the same chip using direct-write E-beam lithography and localised epitaxy. Thomson-CSF has produced integrable modulators and wavelength multiplexers with channel spacing down to 12 nm. All three partners have also integrated laser sources with optical waveguides on the same chip. Using the InGaAlP material system, CSE LT have produced demultiplexers with channel spacings close to the required 30 nm and integrated high-speed (>4 Gbit/s) detectors.
A focal point of the Group A collaboration has been the optoelectronic device simulation facility, developed by GEC-Marconi largely under this programme. Sophisticated numerical techniques have been harnessed using interactive graphic interfaces to provide user-friendly engineering tools, which enable a rapid convergence towards, and verification of, the required design. Low-loss waveguide bends, fabrication-tolerant power splitters and novel wavelength filters and demultiplexers were generated using thisunique facility, and many practical problems of integration addressed. Excellent agreement has been found with the experimental result.
Group B has concentrated on the development of the two key components required in any optical transmission system, namely the optical transmitter and the optical receiver. The main innovation of this work has been the combining of both the optical (laser of photodetector) and electronic (transistor) devices on the same semiconductor chip, an approach which offers the prospect of higher performance, lower cost, reduced size and improved reliability compared with more conventional hybrid components. Excellent progress has been achieved within the project. Two different approaches to the transmitter integration have been developed. The major thrust has been towards integrating the semiconductor laser with a heterojunction bipolar transistor, however, the most successful approach to date has been the integration of the laser with an insulated gate transistor. Successful operation at 1.12 Gbit/s has been demonstrated for a hybridised module containing an integrated heterojunction bipolar transistor driver circu t and a high-speed laser.
The integrated receiver activity within Group B has achieved world-record results. The group has fabricated the most sensitive receiver at 560 Mbit/s with a figure of 32.7 dBm. This circuit comprises an indium gallium arsenide pin photodiode integrated alongside a heterojunction field-effect transistor. These same devices have also been combined into a full transimpedance receiver design with a state-of-the-art integration level of 17 components and operation at up to 2.4 Gbit/s.
Exploitation
The technology developed under ESPRIT 263 is already being exploited under RACE, where high-quality lasers, optoelectronic ICs, low-loss waveguides, etc, are being incorporated into a range of exploratory communication systems and optically switched networks. Beyond this lies a new generation of telecommunications, instrumentation and signal processing applications.
Campo scientifico (EuroSciVoc)
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
- ingegneria e tecnologia ingegneria elettrica, ingegneria elettronica, ingegneria informatica ingegneria elettronica sensori sensori ottici
- ingegneria e tecnologia ingegneria elettrica, ingegneria elettronica, ingegneria informatica ingegneria elettronica elaborazione del segnale
- ingegneria e tecnologia nanotecnologia nanomateriali nanostrutture bidimensionali
- ingegneria e tecnologia ingegneria elettrica, ingegneria elettronica, ingegneria informatica ingegneria informatica telecomunicazioni
- scienze naturali scienze fisiche ottica fisica dei laser
È necessario effettuare l’accesso o registrarsi per utilizzare questa funzione
Programma(i)
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Argomento(i)
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Dati non disponibili
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Invito a presentare proposte
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Dati non disponibili
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Meccanismo di finanziamento
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Dati non disponibili
Coordinatore
10148 TORINO
Italia
I costi totali sostenuti dall’organizzazione per partecipare al progetto, compresi i costi diretti e indiretti. Questo importo è un sottoinsieme del bilancio complessivo del progetto.