Obiettivo
This project involves the development of a process for separating pure proteins, such as enzymes or other products expressed by recombinant (genetically manipulated) organisms. The principle is based on the established procedure in which an anti-body which will react with the required protein is linked to a support (which may be packed in a column) producing an affinity material to which the sample material is brought into contact. The required protein binds onto the column, the impurities are washed off and the required protein is eluted in a pure form. This is a batch process. The purpose of this work is to replace this with a continuous method, binding the affinity material to a looped belt, which then passes through the crude sample, the washing process, a chamber where the required product is eluted and finally is regenerated. In spite of technical difficulties which initially limited yields and process rates, encouraging results were obtained, which should result in development of an effective apparatus.
The most successful of the experimental systems was that based on trypsin. This gave stable and reproducible results and was therefore used for much of the testing and development work. Continuous purifications of trypsin from pancreatic extract were carried out, the longest being of 30 h duration. The recovery was 30 40% at approximately 0.6 mg h 1, and only one contaminant was detected in the product. This was identified as chymotrypsin. which also binds to this affinity ligand. Studies of the factors affecting the the operation of the system showed that there was an inherent compromise between the efficiency of product recovery and the rate of purification. It was found that the problem of recovery were caused by the mixing of the chamber contents into a uniform concentration. A version of the apparatus was constructed that consisted of multiple subchambers for both the adsorption and elution steps of the process. This limited mixing and therefore allowed the formation of a concentration gradient. This proved a success, increasing the recovery of trypsin to 75% at approximately 2 mg h-1 in an unoptimised run. During these separations. the apparatus carried out one complete cycle in approximately 5 minutes and used in total only a small fraction of the amount of ligand of a comparable chromatography process. It was shown to be capable of producing highly purified products in a single step from a crude feedstock. In certain applications the rates of purification were low and belt performance deteriorated with time. These problems may be solved by improved belt materials and optimised operating conditions.
FUTURE ACTIVITY
The new apparatus design and the new belt material with IgG and metal chelation separations have still to be fully tested. But it is apparent that this continuous separation method is capable of efficient operation, as shown with the trypsin purification.
The most effective methods of protein purification involve the removal of the target protein from solution by bringing it into contact with a solid that it can bind to. The binding between the solid and the protein can be made very specific by attaching a compound to the solid that is known to bind very effectively with the desired protein (affinity ligand). This is commonly carried out by column chromatography, where the solid adsorbent particles are packed into a column. The crude mixture is passed through the column and the target protein binds to the particles. After the contaminants are washed away, another liquid is passed through the column that removes the attached protein from the particles, which is then recovered in solution. In the novel continuous separation method developed here, the solid is a belt of material in a continuous loop which moves through a series of chambers containing flows of the liquids necessary for the purification. In contrast to the column format where each step takes place in sequence, in this method all processes are occur simultaneously on different parts of the moving belt. The overall result is that a constant flow of crude material can be processed and a constant flow of purified protein is produced. In addition, since the rates of adsorption and desorption were not limited by the diffusion of the solute into a matrix, faster ligand cycle times could be used. The potential advantages are lower costs through the use of small amounts of affinity ligand, inexpensive support materials, and continuous operation.
ACTIVITIES
This project involved several areas of work that were integrated into the development of this affinity separation method. Apparatus was designed and constructed, and this was tested with several different protein/ligand affinity systems. Studies of the factors affecting separation performance provided insights into the limitations of both the apparatus and the affinity systems that led to improvements in design and methods of operation.
APPARATUS
Three versions of apparatus were used during the project. Initially, basic apparatus was tested. This was later replaced by 2 professionally constructed prototypes of increasing sophistication. The basic design consisted of a multi chambered tank, a belt drive system, and pumps for the delivery of liquid media. The most advanced prototype had built in pumps, drive and control electronics, and a multi roller drive mechanism. For the majority of work, nylon belts were used that were activated by partial hydrolysis. Ligands were attached via gluteraldehyde. This was not satisfactory for all separations due to non specific binding of proteins. A new material was developed by Whatrnan Ltd. that may be better for some applications as it shows low levels of non specific binding. Methods were devised that enabled this to be produced in a belt format that was chemically robust enough for the ligand attachment process and physically strong enough for use in the continuous apparatus. This was not tested in continuous separations as it was only available at the end of the project.
MODEL SYSTEMS
A number of target/ligand affinity systems were investigated on the principle that each could give unique information on the effectiveness of the method. These were: trypsin/trypsin inhibitor, IgG/Protein A, histidine recombinant protein/metal chelation, streptavidin binding recombinant protein/streptavidin, b-galactosidase/ inhibitor, Cu2+/chelation.
Campo scientifico (EuroSciVoc)
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
È necessario effettuare l’accesso o registrarsi per utilizzare questa funzione
Programma(i)
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Argomento(i)
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Invito a presentare proposte
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Dati non disponibili
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Meccanismo di finanziamento
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Coordinatore
RG6 2EF Reading
Regno Unito
I costi totali sostenuti dall’organizzazione per partecipare al progetto, compresi i costi diretti e indiretti. Questo importo è un sottoinsieme del bilancio complessivo del progetto.