Obiettivo
The purpose of the project is to prove the feasibility of the microfiltering process using CARBOSEP membranes in an industrial environment to eliminate catalyzer fines contained in slurry oil, basic product from a catalytic cracker fractioning tower, and especially :
- confirm the separation and capacity performances previously obtained with a laboratory pilot unit
- test the mechanical reliability of the unit
- determine operating cycle times
- evaluate operating costs
- serve as a sizing and extrapolation base for a future unit
- and lastly to evaluate operating modes and especially drop viscosity, eliminate polyaromatic molecules and more than four cycles, etc.
PERFORMANCES
- Since 15/11/89, the unit has operated under very satisfactory conditions requiring hardly any intervention from the refinery personnel.
- The membrane filtering efficiency is very good. The filtrate has a fine content less than 10 ppm.
- The unit responds reversibly to load quality fluctuations (viscosity) and no longer clogs irreversibly.
- Manual regulation consisting in adjusting the transmembrane load loss to the load viscosity has given satisfaction. The filtrate flow is relatively constant (2.3 T/h).
- The concentrate flow is now adjusted to maintain the load flow which maintains the maximum temperature (265 deg. C) in the loop.
- Under these conditions, Table 2 below shows that the system has effectively attained the objective for which it was sized.
PROJECT SUCCESS
We can now conclude with regards to the positive results of these tests performed on an industrial site. These tests made it possible to make the following progress :
- Control of a new tangentialmicrofiltering process with a highly clogging and viscose product.
- Information feedback may have spinoffs even outside the petroleum domain.
- Incorporation of the temperature-viscosity relationship, especially important for this process (refer to Figures 8 and 9) with an industrial unit.
- Consequently, the regulation method has been reviewed and we are now capable of designing a regulation system for a future plant.
- We have learned how to evaluate, in a better manner, the brittleness of filtering membranes. This made it necessary to develop installation and sealing test procedures which have given full satisfaction.
- Works continued after the end of this contract made it possible to envisage the construction of new filtering modules benefiting from experience feedback.
- A double packing pump has been successfully used under exceptionally severe operating conditions and without any wear on the packing.
- Generally speaking, the choice of equipment : regulation valves, flowmeters, etc. seems to have been correct. However, it is necesary to wait for the results from the inspection operation which will take place at the end of the current tests.
- The measurement analysis technique for catalyzer fines has been tested for this type of fluid and can be routinely applied if certain precautions are taken.
The project consists in the replacement of the traditional equipments (hydrocyclones, electrostatic balls loaded contactors) keeping back the fines in the catalytic slurry oil by a microfiltration loop. This loop which contains microfiltration barriers, is fitted to keep back the fines the diameter of which is superior to a certain value (said cutting value), and allows to keep back these fines totally, and not just partially like in traditional equipments.
The use of these barriers to keep back fine particles of catalyst in the concentrate is new.
Campo scientifico (EuroSciVoc)
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
Questo progetto non è ancora stato classificato con EuroSciVoc.
Suggerisci i campi scientifici che ritieni più rilevanti e aiutaci a migliorare il nostro servizio di classificazione.
È necessario effettuare l’accesso o registrarsi per utilizzare questa funzione
Programma(i)
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Argomento(i)
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Invito a presentare proposte
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Dati non disponibili
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Meccanismo di finanziamento
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Coordinatore
92500 Rueil Malmaison
Francia
I costi totali sostenuti dall’organizzazione per partecipare al progetto, compresi i costi diretti e indiretti. Questo importo è un sottoinsieme del bilancio complessivo del progetto.