Obiettivo
The aim is to demonstrate that the efficiency of biomass boilers can be significantly improved by decreasing the temperature of the flue gases to levels at which condensation of combustion products occurs. The addition of a condensation exchanger with high heat transfer coefficients increases the amount of sensible heat which results from the latent heat of the condensed products.
The plant furthermore will demonstrate automatic regulation of excess air and an improved dust separation technique.
Corrosion problems in the tubes of the condensation heat exchanger have resulted in temporary shutdown and bypassing of the heat exchanger. The cause of the corrosion was investigated. It was found that corrosion was caused by surface deposition of the ashes on the horizontal tubes of the condensation heat exchanger. The heat exchanger was replaced with another one made of iron (same material) which was also corroded within one heating season. The boiler operates successfully while the condensation heat exchanger is bypassed. It can be concluded that for boilers in this small scale, this kind of technology is not adequately developed because of the need to remove completely the ashes and organic gases upstream the heat exchanger when operating with biomass of high moisture content.
A plant for producing heat from wood blocks (L 300 mm, D 100 mm) and wood chips as its source of energy will be established at the heating plant of SCI des Mauges, 49300 Cholet France. The plant will provide heating to 672 houses in this area. The boiler has an output of 3000 kW and the condenser produces an additional 600 kW. The overall efficiency is 95 %. The fuel is wood of high moisture content (50 %).
The wood is fed into the boiler by a hydraulic piston, into a flat water-cooled or refractory steel grate. Combustion takes place in a large flame furnace divided into two sections : at the base the fuel is gasified by an adiabatic process and the gas burns at the top by means of secondary air injected through a narrow section providing a proper lean-gas burner. The ash is transported by means of a second piston which advances at regular intervals.
A special process enables the high moisture content fuel to be burnt. It consists of recirculating hot gas taken from the top of the furnace and reinjecting it through the bed of fuel in the furnace inlet zone with a recycling rate of 10-15 %.
A scrubber-heat exchanger is used to condense the flue gases and to remove any remaining dust particles (after the flue gases have been cleaned in a multicyclone). Condensation increases the efficiency of moist biomass boilers.
The control of excess air is based on the measurement of the oxygen concentration (by zirconium dioxide detector) at the flue gases. Depending on this value the boiler programmer adjusts the feed rate of wood fed into the furnace in order to maintain a constant oxygen concentration.
Campo scientifico (EuroSciVoc)
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
Questo progetto non è ancora stato classificato con EuroSciVoc.
Suggerisci i campi scientifici che ritieni più rilevanti e aiutaci a migliorare il nostro servizio di classificazione.
È necessario effettuare l’accesso o registrarsi per utilizzare questa funzione
Programma(i)
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Argomento(i)
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Invito a presentare proposte
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Dati non disponibili
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Meccanismo di finanziamento
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Coordinatore
44042 Nantes Cedex
Francia
I costi totali sostenuti dall’organizzazione per partecipare al progetto, compresi i costi diretti e indiretti. Questo importo è un sottoinsieme del bilancio complessivo del progetto.