Obiettivo
Alleviation/cure of condensation dampness and mould growth in households by extracting moisture from the air, thereby reducing the requirement for high ventilation rates and wasteful space heating. The dehumidifier is estimated as achieving on average a 1/2 kW heat input energy saving. Electricity saving is expected to reach 1,550 kWh/yr per dwelling. Investment cost should be 250 UKL per unit, plus 50 UKL per installation. Expected payback time is 2.3 years.
Analysis of the winter 86-87 monitoring shows that:
- the efficiency is not as high as expected because the deshumidifiers are not running continuously. Several start up/stop are observed.
- the occupants are generally satisfied and a significant improvement about moisture effects is observed.
This analysis is confirmed during the winter 87-88.
The mean values measured in 10 houses fitted with kWh-meters are as follows for one week : 3,0 to 21,0 kWh for water extraction of 1,9 to 14,2 liters resp., giving an efficiency of extraction between 0,73 and 1,74 kWh/liter of water.
- The annual energy saving for one house, with the dehumidifier in partial activity (60 %) during 6 winter months, is calculated as follows :
a) heat restored (500 W) for space heating, from the latent heat of treated air = 1310 kWh
b) electricity needed (380 kWh)
c) further saving (300 W) by reduced ventilation when dehumidifier is not running (40 % of time) : 524 kWh
giving an overall figure of 1310 - 380 +524 = 1454 kWh.
- The inside relative humidity is controlled and is generally below 70 %.
- The qualitative aspect of the project was treated by questionnaires sent after each winter; the analysis of the answers shows that the tenants who returned questionnaires that indicated they were suffering from mould growth and had cleaned it off after the dehumidfier was installed, has a 77-78 % chance of the mould growth not returning.
The general comments indicated that the tenants were happy with the dehumidifier.
1. Dehumidifiers operate using the same thermodynamic principles and components as a domestic refrigerator, having a compressor, and expansion valve, a cold evaporator coil and a hot condensor coil.
A small fan draws air laden with moisture through the evaporator which cools it below dew point temperature. This causes condensation of water on the evaporator coil surfaces. The water then drains away under gravity into a collector bucket, or is piped away to the exterior of the dwelling. The cooled, dryed air then passes over the hot condenser coil and returns to the room, warmer and dryer. All of the electrical energy consumed by the dehumidifier's fan and compressor is returned to the atmosphere as heat. In addition, the latent heat of vaporisation of the condensing moisture, is transferred to the out-going air. The dehumidifier therefore, supplied 10 to 30% more heat energy to the surrounding room than it consumes electrically and for this reason the machine is often referred toas a 'heat pump dehumidifier'.
2. Substantial improvements in the performance of conventional dehumidifiers can be made by installing a specially designed heat exchanger between the evaporator and condenser. The cold air from the evaporator is used to cool the incoming air and it in turn is heated before passing over the condenser. In short, this improves the thermodynamic efficiency of the system which is reflected in the efficiency as a significant reduction in the electricity required to extract a given amount of water from the air. A dehumidifier which incorporates these operating features is known as an 'advanced' (or geared) dehumidifier.
3. The power of a single unit is 145 W. The project is to be carried out in approximately 100 Council-owned dwellings in various properties (houses, flats, maisonettes, bungalows), ages, construction and exposure to climatic conditions.
Campo scientifico (EuroSciVoc)
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
CORDIS classifica i progetti con EuroSciVoc, una tassonomia multilingue dei campi scientifici, attraverso un processo semi-automatico basato su tecniche NLP. Cfr.: Il Vocabolario Scientifico Europeo.
Questo progetto non è ancora stato classificato con EuroSciVoc.
Suggerisci i campi scientifici che ritieni più rilevanti e aiutaci a migliorare il nostro servizio di classificazione.
È necessario effettuare l’accesso o registrarsi per utilizzare questa funzione
Programma(i)
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Programmi di finanziamento pluriennali che definiscono le priorità dell’UE in materia di ricerca e innovazione.
Argomento(i)
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Gli inviti a presentare proposte sono suddivisi per argomenti. Un argomento definisce un’area o un tema specifico per il quale i candidati possono presentare proposte. La descrizione di un argomento comprende il suo ambito specifico e l’impatto previsto del progetto finanziato.
Invito a presentare proposte
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Dati non disponibili
Procedura per invitare i candidati a presentare proposte di progetti, con l’obiettivo di ricevere finanziamenti dall’UE.
Meccanismo di finanziamento
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Meccanismo di finanziamento (o «Tipo di azione») all’interno di un programma con caratteristiche comuni. Specifica: l’ambito di ciò che viene finanziato; il tasso di rimborso; i criteri di valutazione specifici per qualificarsi per il finanziamento; l’uso di forme semplificate di costi come gli importi forfettari.
Coordinatore
S1 1UJ SHEFFIELD
Regno Unito
I costi totali sostenuti dall’organizzazione per partecipare al progetto, compresi i costi diretti e indiretti. Questo importo è un sottoinsieme del bilancio complessivo del progetto.