Ziel
Construction and operation of a demonstration plant with a capacity of 1,500 T/D raw brown coal using the Winkler process at high temperature (1,000 deg. C) and under pressure (10 Bar). The subjects of this new application are to increase productivity and also to prove the higher availability necessary to justify a commercial plant, to test the plant behaviour at varying loads and to perform some extended time tests. Operation in "Combined-cycle power plant" mode. Determination of the impact on the environment.L%
Although during the period under review there were two planned standstills in April and November of 1988, the gasifier worked a total of 6,210 hours in hot operation and the gas treatment unit, i.e. the CO2/H2S scrubbing unit, operates 6,016 hours. The longest continuous gasifying operation to date of 1,728 hours which corresponds to approx. 72 days was recorded for the months August to October. In the period under review 154,198 t (t = tonne) of dry brown coal was converted to produce a total of 210 mill. m3 (STP) of synthesis gas, 202 mill. m3 (STP) of which was processed in the methanol synthesis unit of the Union Rheinische Braunkohlen Kraftstoff AG (Union Kraftstoff) at Wesseling. During Phase 2D it was possible to increase the availabilities to 71% for the gasifier and to 69% for the gas treatment units.
The most important measure taken within the scope of the work programme of Phase 2D is the addition of a new final scrubbing stage to plant unit 09, viz. sulphur recovery, which started successfully in January 1989. Now it is possible to desulphurize the total amount of acid gas to a pure gas concentration of smaller than 2 vppm H2S. Further important measures were the tests made with new screw shaft sealings and a modified coal dosing system, the reduction in the number of gasifier nozzles and investigations dealing with ammonia cracking in the gasifier, catalyst behaviour, materials etc.
The HTW process is a gasification process based on the fluidized bed technology developed by Fritz Winkler in 1922. Gasification in the advanced HTW process takes place under pressure at a temperature of up to 1000 deg. C, with oxygen and steam as gasifying agents.
The High Temperature Winkler process features :
- high mass and energy transfers with a smooth temperature distribution;
- low consumption of gasifying agents;
- high degree of carbon conversion since gasification takes place in the fluidized bed and in the entrained gasification zone;
- suitability for a large variety of feedstocks (lignite, slightly caking hard coal, wood, peat, biomass);
- large product range (synthesis gases, reducing gas, hydrogen, low-BTU gas);
HTW demonstration plant data :
Gasification pressure 10 Bar
Gasification temperature approx. 950 deg. C
Dry lignite input capacity 30. 5 t/h
Synthesis gas output capacity 37000 m3/h
Methanolequivalent 14 t/h
Dry lignite is transported by a belt conveyor from the Berrenrath refining plant to the storage bunker.
From the weighing vessels the lignite passes through pressurized lock hoppers and reaches the feeding vessels from where it is supplied by dosing and feeding screws to the fluidized bed.
In the gasifier, lignite reacts with oxygen and steam as gasifying agents at a pressure of 10 Bar and temperatures of up to 1000 deg. C. Oxygen is fed into the gasifier at different levels. Temperatures in the fluidized bed range from 700 to 800 deg. C.
In the entrained gasification zone above, carbon conversion and gas quality are further improved at temperatures reaching 1000 deg. C. The product gas leaves the gasifier at the top. Ash and carbon containing dust particles carried along by the raw gas are removed in a cyclone and recirculated to the fluidized bed. A second cyclone removes the remaining finer dust particles.
The hot raw gas is cooled tosome 350 deg. C in a waste heat boiler. The heat energy is used to generate medium pressure steam which serves as process steam in the gasifier. The remaining heat is used for saturating the raw gas with steam in a quench cooler.
CO-shift conversion is used to obtain the required ratio of hydrogen to carbon monoxide.
Subsequently, sulphur compounds and carbon dioxide are almost completely removed in a Rectisol scrubber with methanol acting as a solvent. The sulphur compounds are processed into saleable elementary sulphur.
The processed and cleaned synthesis gas is piped to the Union Kraftstoff AG where tests are made on the conversion of lignite derived synthesis gas into methanol.
One important future field of application for the HTW process is constituted by low-BTU gas production from lignite for use in combined-cycle power stations.
Wissenschaftliches Gebiet (EuroSciVoc)
CORDIS klassifiziert Projekte mit EuroSciVoc, einer mehrsprachigen Taxonomie der Wissenschaftsbereiche, durch einen halbautomatischen Prozess, der auf Verfahren der Verarbeitung natürlicher Sprache beruht. Siehe: Das European Science Vocabulary.
CORDIS klassifiziert Projekte mit EuroSciVoc, einer mehrsprachigen Taxonomie der Wissenschaftsbereiche, durch einen halbautomatischen Prozess, der auf Verfahren der Verarbeitung natürlicher Sprache beruht. Siehe: Das European Science Vocabulary.
Dieses Projekt wurde noch nicht bei EuroSciVoc klassifiziert.
Schlagen Sie die Wissenschaftsbereiche vor, die Ihrer Einschätzung nach besonders relevant sind, und helfen Sie uns, unseren Klassifizierungsdienst zu verbessern.
Sie müssen sich anmelden oder registrieren, um diese Funktion zu nutzen
Programm/Programme
Mehrjährige Finanzierungsprogramme, in denen die Prioritäten der EU für Forschung und Innovation festgelegt sind.
Mehrjährige Finanzierungsprogramme, in denen die Prioritäten der EU für Forschung und Innovation festgelegt sind.
Thema/Themen
Aufforderungen zur Einreichung von Vorschlägen sind nach Themen gegliedert. Ein Thema definiert einen bestimmten Bereich oder ein Gebiet, zu dem Vorschläge eingereicht werden können. Die Beschreibung eines Themas umfasst seinen spezifischen Umfang und die erwarteten Auswirkungen des finanzierten Projekts.
Aufforderungen zur Einreichung von Vorschlägen sind nach Themen gegliedert. Ein Thema definiert einen bestimmten Bereich oder ein Gebiet, zu dem Vorschläge eingereicht werden können. Die Beschreibung eines Themas umfasst seinen spezifischen Umfang und die erwarteten Auswirkungen des finanzierten Projekts.
Aufforderung zur Vorschlagseinreichung
Verfahren zur Aufforderung zur Einreichung von Projektvorschlägen mit dem Ziel, eine EU-Finanzierung zu erhalten.
Daten nicht verfügbar
Verfahren zur Aufforderung zur Einreichung von Projektvorschlägen mit dem Ziel, eine EU-Finanzierung zu erhalten.
Finanzierungsplan
Finanzierungsregelung (oder „Art der Maßnahme“) innerhalb eines Programms mit gemeinsamen Merkmalen. Sieht folgendes vor: den Umfang der finanzierten Maßnahmen, den Erstattungssatz, spezifische Bewertungskriterien für die Finanzierung und die Verwendung vereinfachter Kostenformen wie Pauschalbeträge.
Finanzierungsregelung (oder „Art der Maßnahme“) innerhalb eines Programms mit gemeinsamen Merkmalen. Sieht folgendes vor: den Umfang der finanzierten Maßnahmen, den Erstattungssatz, spezifische Bewertungskriterien für die Finanzierung und die Verwendung vereinfachter Kostenformen wie Pauschalbeträge.
Koordinator
50935 Köln
Deutschland
Die Gesamtkosten, die dieser Organisation durch die Beteiligung am Projekt entstanden sind, einschließlich der direkten und indirekten Kosten. Dieser Betrag ist Teil des Gesamtbudgets des Projekts.