Skip to main content
Ir a la página de inicio de la Comisión Europea (se abrirá en una nueva ventana)
español español
CORDIS - Resultados de investigaciones de la UE
CORDIS

Clean and efficient microCHCP by micro turbine based hybrid systems

CORDIS proporciona enlaces a los documentos públicos y las publicaciones de los proyectos de los programas marco HORIZONTE.

Los enlaces a los documentos y las publicaciones de los proyectos del Séptimo Programa Marco, así como los enlaces a algunos tipos de resultados específicos, como conjuntos de datos y «software», se obtienen dinámicamente de OpenAIRE .

Resultado final

Data Management Plan (DMP) (se abrirá en una nueva ventana)

The DMP outlines what data will be generated and collected, the used methodology and standards for data collection and describes how the research data is made available during the project as well as preserved after completion of the project.Linked to Task 8.2

Dissemination, Exploitation and Communication plan 1 (se abrirá en una nueva ventana)

The plan will contain the following elements 1 identification of specific target groups and a mapping of key stakeholders at EU and at national level for project outreach and dissemination 2 the initial key messages and information relevant for each target group 3 the tools and channels that will be used to convey the messages and the information to each target group 4 schedule of activities until M18Linked to Task 82

Production report of 200 L reference-quality HPO (se abrirá en una nueva ventana)

Production report of 200 L reference-quality HPO, describing the used feedstock, the applied operating conditions and final product specifications based on analysis results.Linked to Task 2.1

Dissemination, Exploitation and Communication plan 2 (se abrirá en una nueva ventana)

Revision of the original plan, updating the schedule of activities until M36Linked to Task 8.2

Operating parameters combustor (se abrirá en una nueva ventana)

The first step in the development of the combustor is to characterize operating parameters and requirements eg fuel and air supply operating pressure relevant temperatures These parameters will be documented and regularly updated based on the gained experience of the system Deliverable is linked to task 31Linked to Task 31

Report on 4 use case definitions for system development and evaluations (se abrirá en una nueva ventana)

Report on 4 use case definitions for system development and evaluations: At least 4 use cases will be defined (heating and/or cooling demands, climate zone, building types), which will then be used for system development and evaluation of potential.Linked to Task 5.1

Publicaciones

Humidification Impact on the Performance Improvement of a Novel Two-Shaft Micro Gas Turbine: Thermodynamic Cycle Performance Assessment (se abrirá en una nueva ventana)

Autores: Ali Baghernejad, Danish Rehman, Michel Delanaye, Ward De Paepe
Publicado en: Volume 5: Cycle Innovations, 2024
Editor: American Society of Mechanical Engineers
DOI: 10.1115/GT2024-128549

Clean and efficient microCHCP by micro turbine-based hybrid systems: The Fit4Micro project (se abrirá en una nueva ventana)

Autores: Delanaye, M., Rehman D, Bjorn Aaen S, Lokke S, Leijenhorst E, Van de Beld B, Korteweg H, Tudoroiu A, Baghernejead A, De Paepe W, Hermann R, Nonnen T, Velte A, Fuldner G, Ramaswamy S, Harboe-Minwegen S, Ridolfi T, Capaccioli S
Publicado en: European Biomass Conference and Exhibition Proceedings, 2023, ISSN 2282-5819
Editor: ETA Florence Renewable Energies
DOI: 10.5071/31STEUBCE2023-3CV.4.10

Optimal waste heat recovery through humidification in 2-spool micro gas turbines: A comparative study of advanced humidified cycles (se abrirá en una nueva ventana)

Autores: Aggelos Gaitanis; Francesco Contino; Ward De Paepe
Publicado en: Energy, 2025, ISSN 1873-6785
Editor: Elsevier
DOI: 10.2139/SSRN.5087255

Buscando datos de OpenAIRE...

Se ha producido un error en la búsqueda de datos de OpenAIRE

No hay resultados disponibles

Mi folleto 0 0