Skip to main content

Increasing resource efficiency of aviation through implementation of ALM technology and bionic design in all stages of an aircraft life cycle

Deliverables

Project website

Project website

Leaflet, posters and brochures

initial Version: M6 updates/follow up material: M12, M18, M24, M30, M36

Pre-exploitation Plan for each partner

Pre-exploitation Plan for each partner

Report on the contribution to the standardization system

Report on the contribution to the standardization system

Searching for OpenAIRE data...

Publications

BionicAircraft - Increasing resource efficiency of aviation through implementation of ALM technology and bionic design in all stages of an aircraft life cycle

Author(s): Ph. Imgrund
Published in: AM-Motion European Strategic Approach on Additive Manufacturing, 2017

New high-strength Aluminium Alloys and Bionic Design for the SLM Process

Author(s): F. Teng, M. Gralow
Published in: Symposium on resource efficient manufacturing of functional components made of technical metals, 2017

BionicAircraft - Increasing resource efficiency of aviation through implementation of ALM technology and bionic design in all stages of an aircraft life cycle

Author(s): Ph. Imgrund
Published in: The Bionic Network Event 2017, 2017

IN-SERVICE INSPECTION OF AERONAUTICS PARTS PRODUCED BY ADDITIVE LAYER MANUFACTURING (ALM) - in the framework of Bionic Aircraft project (GA nº 690689)

Author(s): Galarza, N.; Rubio, B.; Bereziartua, A.; Lozano, I.; Gascon, Jaime; Atxaga, G.; Perez, J.; Rubio, J.
Published in: Proceedings of AEND 2019, Issue 1, 2019

Optimization of the Laser Additive Manufacturing Process by Beam Shaping




Repair of Al components by low temperature high velocity combustion spraying for aeronautic applications




Innovative workflow for bionic design and structural optimization of ALM parts




Bionic Aircraft- Enhancing resource efficiency of aviation through implementation of ALM technology and bionic design in all stages of an aircraft life cycle




Innovative in-process and in-line quality assurance systems for additive layer manufacturing




Measurement of actual powder layer height and packing density in a single layer in selective laser melting

Author(s): Tim Marten Wischeropp, Claus Emmelmann, Milan Brandt, Aaron Pateras
Published in: Additive Manufacturing, Issue 28, 2019, Page(s) 176-183, ISSN 2214-8604
DOI: 10.1016/j.addma.2019.04.019