Descrizione del progetto
Maneggiare con cura, ma esercitando pressione
Alcuni compositi hanno in gran parte sostituito i metalli in numerose strutture per velivoli, diminuendone notevolmente il peso, il consumo di carburante e le emissioni e migliorandone allo stesso tempo le prestazioni. Lo scatolato alare di un velivolo rappresenta uno dei componenti strutturali compositi da cui si estende l’ala. Esso è soggetto a carichi ingenti, facendo sì che la sua integrità influisca non solo sulla sicurezza, ma anche sull’aerodinamica, rendendo di fondamentale importanza la solidità strutturale dei componenti. Il progetto WIBOND, finanziato dall’UE, realizzerà uno strumento di montaggio a incollaggio in grado di posizionare l’adesivo, di applicare la pressione adeguata e di incorporare i sensori a fibre ottiche nella linea di incollaggio per il monitoraggio strutturale del collante. Tale tecnologia fornirà supporto al dimostratore aeronautico di Clean Sky e a ulteriori soluzioni innovative.
Obiettivo
An innovative flexible jig will be designed and fabricated to allow the structural bonding of a SAT composite wingbox. TM will use the jig to Join internal ribs and lower panel to the upper panel where 3 spar are already cocured. The bonding process will be performed using a paste adhesive that require the application of a calibrated pressure on the bond line. To allow the control of effective bonding an SHM system based on fiber optic sensors will be embedded in the bonding line. Therefore the jig must allow the bonding operation like paste adhesive application and squeezing while holding the required part position during the process. The Consortium propose a jig with a part that sliding on a lower base give all the necessary accessibility for rib bonding and position of SHM sensors. It will be necessary to develop suitable guidelines for the bonding jig. Different methods to hold the part positioning and give bonding pressure application will be evaluated including mechanical and enflatable devices. As experimental verification is considered necessary to fulfill the requirements, before full scale jig design and fabrication, subscale trial will be performed by WIBOND consortium. Guidelines on the process delivered by TM integrated with know-how of WIBOND on assembly and bonding jig will be tested on a subscale, representative bonding jig. Detailed Jig design will be performed. It includes 3D models, 2D tables, stress, thermal & tolerance analysis. Partially in parallel with design, to meet the tight schedule, Jig components will be fabricated and assembled using state of art control equipment like Laser tracker and galvanometric Harm. Jig will be delivered and installed at TM Premises were also try out and training of operators will be performed. Lightweight recyclable materials will be used for main structure and components. Jig will be have provision for self heating but the heating system isn’t included in the baseline proposal.
Campo scientifico
- engineering and technologymaterials engineeringfibers
- engineering and technologycivil engineeringstructural engineeringstructural health monitoring
- engineering and technologymechanical engineeringthermodynamic engineering
- engineering and technologyelectrical engineering, electronic engineering, information engineeringelectronic engineeringsensors
- natural sciencesphysical sciencesopticsfibre optics
Programma(i)
Meccanismo di finanziamento
CS2-IA - Innovation actionCoordinatore
84012 Angri
Italia
L’organizzazione si è definita una PMI (piccola e media impresa) al momento della firma dell’accordo di sovvenzione.