Skip to main content
Przejdź do strony domowej Komisji Europejskiej (odnośnik otworzy się w nowym oknie)
polski pl
CORDIS - Wyniki badań wspieranych przez UE
CORDIS
Zawartość zarchiwizowana w dniu 2024-05-28

Development and Validation of an automated Ultrasonic system for the Non-Destructive Evaluation (NDE) of welded joints in thermoplastic storage tanks

Cel

Plastics tanks are normally designed for a finite life, usually between 15 and 25 years. However, due to economic pressure many of these tanks are still in operation beyond their design life, often with little or no engineering justification. It is also not uncommon for plastics tanks to be used for storing chemicals that they were not designed to contain. For these reasons it is important that operators of plastics tanks and vessels inspect them throughout their life. An issue at hand is that there are currently no standards for the in-service inspection of plastics tanks. There is also very limited expertise available on the visual examination of these tanks and virtually no use of non-destructive examination (NDE). Internal inspections are carried out less frequently, if at all, because they are expensive, potentially dangerous to the inspector, and result in a shut-down because the tank has to be emptied.
The project will determine the potential failure mechanisms in plastics tanks and storage vessels, and develop ultrasonic NDE procedures, techniques and systems to identify these. An important aim of the project will be to develop an inspection system that is site-rugged and simple to operate. Welded joints representative of those used to fabricate plastics tanks and vessels will be manufactured containing known flaws. These will be inspected and the NDE data analysed to determine the limits of flaw detection. In parallel, the significance of flaw size and quantity will be established in relation to service requirements. This will be achieved by long-term mechanical testing of joints containing known flaws, and comparison with results for welds containing no flaws.
The prototype equipment, designed and built for this project, will be assessed under both laboratory and field conditions, and the inspection procedures developed will be submitted to the European Committee for Standardization as the basis for producing a European standard for plastic tank inspection.

Dziedzina nauki (EuroSciVoc)

Projekt nie został jeszcze sklasyfikowany według klasyfikacji EuroSciVoc.
Wskaż dziedziny nauki, które twoim zdaniem są najbardziej istotne z punktu widzenia tego projektu i pomóż nam usprawnić naszą usługę klasyfikacji.

Program(-y)

Temat(-y)

Zaproszenie do składania wniosków

FP7-SME-2012
Zobacz inne projekty w ramach tego zaproszenia

System finansowania

BSG-SME - Research for SMEs

Koordynator

CHEM RESIST GROUP LIMITED
Wkład UE
€ 257 200,00
Adres
LOCKWAY RAVENSTHORPE IND ESTATE BRITANNIA HOUSE
WF13 3SX DEWSBURY
Zjednoczone Królestwo
Rodzaj działalności
Private for-profit entities (excluding Higher or Secondary Education Establishments)
Linki
Koszt całkowity
Brak danych

Uczestnicy (8)