Skip to main content

Robotized Orbital Drilling Equipment and Optimized residual stresses

Cel

The main objective of the RODEO project is to propose a lightweight robotized orbital drilling equipment, and associated operating conditions and tools, to enable the drilling of tightly spaced small diameter holes in aluminium with the control of induced residual stresses. This will be accomplished by:
- modelling the phenomena involved in orbital drilling that impact residual stresses
- developing a combined drilling and burnishing tool and associated operating conditions to attain required residual stresses
- pursuing the development of a high-speed orbital drilling unit (existing in the consortium) capable to drive the tool in the prescribed conditions
- integrating the developed orbital drilling unit on a lightweight industrial robot
- defining the operating conditions of the lightweight robot to be used to ensure the drilling operation
To reach this objective, numerical simulation tools (already developed in the consortium) will be used to pursue the study and determine the mechanisms modifying the properties of the material during orbital drilling, and the impact on fatigue life (including the influence of a fastener). As a result, solutions to increase residual stresses in aluminium holes will be suggested in terms of cutting conditions, tool geometry and holemaking strategy (including burnishing). From this, an innovative orbital drilling tool, combining cutting and burnishing active parts will be developed and associated operating conditions will be proposed. To drive this tool along the expected trajectory with the required speeds, the development of a high-speed orbital drilling unit (provided by PRECISE) will be pursued. This will require the adaptation of the equipment to allow burnishing, and the integration of monitoring devices for cutting forces, spindle speed, feed speeds measurements. The orbital drilling unit will be handled by a lightweight industrial robot that will permit to drill holes without the need of a drill jig, allowing the drilli

Zaproszenie do składania wniosków

H2020-CS2-CFP03-2016-01
Zobacz inne projekty w ramach tego zaproszenia

Koordynator

PRECISE FRANCE
Adres
1 Avenue De Usinage Grande Vitesse
74250 Peillonnex
Francja

Zobacz na mapie

Rodzaj działalności
Private for-profit entities (excluding Higher or Secondary Education Establishments)
Wkład UE
€ 99 992,50

Uczestnicy (4)

UNIVERSITE PAUL SABATIER TOULOUSE III
Francja
Wkład UE
€ 164 965
Adres
Route De Narbonne 118
31062 Toulouse Cedex 9

Zobacz na mapie

Rodzaj działalności
Higher or Secondary Education Establishments
UNIVERSITE DE NANTES
Francja
Wkład UE
€ 50 000
Adres
Quai De Tourville 1
44035 Nantes Cedex 1

Zobacz na mapie

Rodzaj działalności
Higher or Secondary Education Establishments
MITIS
Francja
Wkład UE
€ 55 003,75
Adres
12 Rue Johannes Gutenberg
44340 Bouguenais

Zobacz na mapie

Rodzaj działalności
Private for-profit entities (excluding Higher or Secondary Education Establishments)
KUKA SYSTEMS AEROSPACE
Francja
Wkład UE
€ 130 037,50
Adres
80 Avenue De Magudas
33185 Le Haillan

Zobacz na mapie

Rodzaj działalności
Private for-profit entities (excluding Higher or Secondary Education Establishments)